帶內孔凸緣端蓋的沖壓拉深級進模具設計【含14張CAD圖帶卡片】
【需要咨詢購買全套設計請加QQ1459919609】圖紙預覽詳情如下：
端 蓋 沖 壓 拉 深 模 的 設 計摘要： 本設計題目為端蓋產品的模具設計，系統的介紹了沖壓拉深件的工藝及模具結構對制件的影響，模具工作零件和總裝結構的設計。介紹了端蓋產品的沖壓拉深設計時應當注意的問題，并且考慮了模具的安裝與調試對零件精度的影響。從控制制件的尺寸精度出發，對工作零件的主要的尺寸進行了理論計算，并用CAD軟件進行各重要零件的設計。通過對該模具的設計，進一步加強了設計者的沖壓模具設計的基礎知識，為以后的復雜的設計打下了基礎與吸取更深刻的經驗。關鍵詞：端蓋 沖壓拉伸 工藝分析 模具結構ICover blanking and drawing mold of designAbstract: In order to carry the mold of cover product design this design topic, system of introduction blunt press craft and mold structure of piece to make a piece of influence, mold work spare parts with total pack structure of design. Introduction carry cover product of blunt press design should attention of problem, and consideration mold of install with adjust to try to influence spare parts accuracy.The size accuracy that is from the control system piece set out, to work spare parts of main of the size carried on theories calculation and counteract CAD software to carry on each importance spare parts ofdesign. Pass a rightness that a mold of design, further strengthenned design of blunt foundation knowledge that press mold's design, is later of complications of design the dozen descended foundation with absorb deeper experience.Keywords: Cover Blanking and Drawing Craft analysis Mold structure