《外文翻譯--打包機組液壓原理及液壓系統維護》由會員分享，可在線閱讀，更多相關《外文翻譯--打包機組液壓原理及液壓系統維護（11頁珍藏版）》請在裝配圖網上搜索。

外文 1 he of s of in of t in a of is in a of 1.1 is of C a on of ) as to on to do be or to T 15 (6 of in a 68.1 or to on a of to of or of is to st as an to by 20.1 1.1 22.1 36.1 71 72 46 of on on 6 in 62.1 in to 3 9 48 68.1 is as 20.1 1.1 22.1 36.1 71 72 73 a 8.1 to at on at 6 6 of of of be is of of as to is to is on on of a of at in of 8.1 on 66.1 to 4.1 is to by 6 in to is of to at on to to 8.1 to by in 6, to on As to to of so as to a in a at to by in 6, to on 5.2 of , of to to to a of in to as At in to is of of be of (1) in of of a (2) il so of (3) of a of (4) a to (5) of 1.2 文 3 A of .5 m3 on of is On of to a a in on of be is a be in a a of 42.3 l / of 0.3 l / of of in at of to a of of in of me of me of of of so m. / 0 an .0 of of to of of 0 ℃ . 2 of is it of to of of as as is to of 2.2 of of is in in of (1) (2) of a a (3) of of (4) as to (5) of il is to in 2.3 (1) of a be is as in so to be (2) of in as in (3) of in of of in or of (4) in of to or as (5) as (6) a so to il it to be a on a "(of by in of on of m on of mL m of mL 5 by a 0/17. (1) (2) of 00 mL of in of (3) at of at of of is (I) to is a as (is a of (of (H or (V) a 文 5 in of if to a of or or of or or (4) is of in by to of to of of to be of of be of it be 2.5 (1) of (2) a or of be (3) of be be of of (1) of by to to in of (2) as to in be to to in (3) il to as to (4) be no to to of to of (5) of be to a be of to (6) on be in (7) to is an to be to 2.6 (1) a if of (2) If is as to to (3) If be on as (4) to it is if be (5) of a in be (6) be 2 be (7) on (8) 7 Pa be to (9) of be is (10) be of of so as to to (11) or be to so as to (12) be to of 文 43 打包機組液壓原理及液壓系統維護 摘 要 介紹預壓打包機液壓系統的組成和工作原理 及簡析了該系統的特點，并詳細介紹其液壓系統維護 . 關鍵詞 液壓系統 液壓系統維護 當前，液壓技術在實現高壓大流量、高效率、經久耐用、高度集成化等各項要求方面都取得了重大進展，正日益顯示出勃勃生機 1打包機組液壓傳動工作原理及其組成部份 液壓系統是預壓打包機組的核心部分，液壓系、統的好壞直接影響到預壓打包機組的工作性能 圖 1)主要由液壓泵站、液壓管路系統及油缸等組成，液壓泵站又由油箱、液壓泵組、控制閥 組、過濾冷卻系統等部分組成，預壓油缸和提升油缸的動作是依靠液壓力來實現的 油泵的壓力油均可以通過電磁溢流閥或換向閥的中位機能來卸荷 5 16電時，序號 控單向閥打開，可使預壓油缸形成差動回路，實現自由下落式快速下行功能，在自由下落階段充液油箱能通過充液閥（序號 主缸上腔快速補充油液 速等多種運行速度要求，各單向節流閥可調節油缸運行速度或緩沖速度，冷卻系統可以嚴格控 制油溫，精濾系統可以提高液壓油的清潔度，這些都是保證液壓系統工作可靠的有效措施 號預壓機為例來說明：啟動油泵電機后，油經 油濾油器、 振接頭、 泵、 向閥、向閥、 71 高壓軟管、 72 高壓軟管、 46 電磁溢流閥流回油箱 時 46 電磁溢流閥電磁鐵得電、 位四通電磁換向閥得電，控制油經 73高壓軟管、 79 高壓軟管、 48 截止閥到 68