錢營孜煤礦3.0 Mta新井設計含6張CAD圖-采礦工程.zip,錢營孜煤礦3.0,Mta新井設計含6張CAD圖-采礦工程,錢營孜,煤礦,3.0,Mta,設計,CAD,采礦工程 任務書 設計日期：20XX年3月12日 至 20XX年6月8日 設計題目： 錢營孜煤礦3.0 Mt/a新井設計 設計專題題目：煤礦沖擊礦壓及防治技術 設計主要內容和要求： 以實習礦井錢營孜煤礦條件為基礎，完成錢營孜煤礦3.0Mt/a新井設計。主要內容包括：礦井概況、礦井工作制度及設計生產能力、井田開拓、首采區設計、采煤方法、礦井通風系統、礦井運輸提升等。 結合煤礦生產前沿及礦井設計情況，撰寫一篇關于煤礦沖擊礦壓及防治技術的專題論文。 完成2與采礦有關的科技論文翻譯一篇，題目為“Input to the application of the convergence con?nement method with time-dependent material behaviour of the support”，論文26672字符。 院長簽字： 指導教師簽字：摘 要 本設計包括三個部分：一般部分、專題部分和翻譯部分。 一般部分為錢營孜煤礦3.0Mt/a新井設計。錢營孜礦位于安徽宿州市西南，交通便利。井田東西長約9km，傾向（南北）長約8km，井田總面積為74.15 km2。主采煤層為32號煤層，平均傾角為9.6°，煤層平均總厚為2.89m。井田地質條件較為簡單。井田工業儲量為338.91Mt，礦井可采儲量255.16Mt，年產量300萬t。礦井服務年限為60.8a，涌水量不大，礦井正常涌水量為320m3/h，最大涌水量為465m3/h。礦井瓦斯涌出量較低，為低瓦斯礦井。 井田為立井單水平開拓。大巷采用膠帶運輸機運煤，輔助運輸采用齒軌車設備。礦井通風方式為混合式通風。 礦井年工作日為330d，日提升時間16小時，工作制度為“三八”制。 一般部分共包括10章：1.礦區概述及井田地質特征；2.井田境界和儲量；3.礦井工作制度及設計生產能力、服務年限；4.井田開拓；5.準備方式-盤區巷道布置；6.采煤方法；7.井下運輸；8.礦井提升；9.礦井通風與安全技術；10.礦井基本技術經濟指標。 專題部分題目是煤礦沖擊礦壓理論及防治技術。 翻譯部分題目為：Input to the application of the convergence confinement method with time-dependent material behaviour of the support  ABSTRACT The general part, special subject part and translated part are included in this design. The general part is a new design of Qianyingzi mine. Qianyingzi mine lines in Southwest of Suzhou in Anhui Province. The traffic of road and railway is very convenience to the mine. The run of the minefield is 9 km ,the tilt length of the minefield is about 8 km，well farmland total area is 74.15㎞2.The 32 is the main coal seam, and its average inclination is 9.6 degree. The thickness of the mine is about 2.89m in all. The proved reserves of the minefield are 338.91 million tons. The recoverable reserves are 255.16 million tons. The designed productive capacity is 3.0 million tons percent year, and the service life of the mine is 60.8 years. The normal flow of the mine is 320 m3 percent hour and the max flow of the mine is 465 m3 percent hour. The mineral well gas gushes the deal lower, for low gas mineral well. Minefield use the vertical shaft with single level to development. Roadway by belt conveyor to transport coal and auxiliary transport by the cog vehicle equipment.The minefield has two air shaft to ensure that the work place can get enough of fresh air. The working system “three-eight” is used in the Qianyingzi mine. It produced 330d/a. The main shaft transport coal 16 hours per day. This design includes ten chapters: 1.An outline of the mine field geology; 2.Boundary and the reserves of mine; 3.The service life and working system of mine; 4.development engineering of coalfield; 5.The layout of panels; 6. The method used in coal mining; 7. Transportation of the underground; 8.The lifting of the mine; 9. The ventilation and the safety operation of the mine; 10.The basic economic and technical norms. Special subject parts of topics is Mine rockburst control techniques. English topic is: Input to the application of the convergence confinement method with time-dependent material behaviour of the support.