摘 要
本文主要對沖壓模具及其自動送料機構的設計，它的工作過程如下：在送料之前，要先用手柄抬起萬向聯結節(jié)，以便在上下輥軸之間形成空隙，將薄板料從間隙穿過，然后按下手柄壓緊入料。當上?；爻虝r，通過曲柄搖桿機構中的搖桿帶動下輥順時針旋轉，從而帶動主動輥和從動輥同時旋轉完成送料工作。當上模下行時，因為下輥的緣故，輥軸停止不動，接著就是完成沖壓的工序了。當偏心輪再次回程，又重復上述動作，照此循環(huán)動作，達到間歇送料的目的。
通過對沖壓模具及其自動送料機構的設計，使三年所學的機械專業(yè)知識在實踐中加深了認識，并且相當于進行了一次全面性的復習。
Abstract
This article mainly to the ramming mold and the feed control organization design, its work process is as follows: In front of feeding, must use the handle to lift the rotary association tubercle first, in order to forms the crevice between about stone roller, the thin sheet from the gap traversing, then presses down the handle to contract into the material. When top die return trip, through crank rocker organization in rocking bar impetus lower roll clockwise rotation, thus the impetus drive roll and the underdriven roll simultaneously revolve complete the feeding work. When top die downward, because of the lower roll reason, the stone roller stops motionless, then was completes the ramming the working procedure. When eccentric once more return trip, also duplicates the above movement, according to this the cyclic action, achieves the intermittent feeding the goal.
Through to the ramming mold and the feed control organization design, made the machinery specialized knowledge which three years institute studied to deepen the understanding in reality, and was equal in has carried on an integrity review.