0028-端蓋拉深成形工藝及模具設計（落料拉伸復合模設計）,端蓋拉深,成形,工藝,模具設計,拉伸,復合,設計 端蓋的沖壓工藝及模具設計 摘要：此次畢業設計任務是端蓋零件的模具設計。端蓋為有凸緣圓筒形件，是典型的拉深件，其拉深過程中變形區的應力狀態和變形特點與無凸緣圓筒形件是相同的，但有凸緣圓筒形件拉深時，胚料凸緣部分不是全部進入凹模洞口，當拉深進行到凸緣外徑等于零件凸緣直徑時，拉深工作就停止。 良好的工藝性和合理的工藝方案，可以用最少的材料，最少的工序和工時，使得模具結構簡單且模具壽命長，能穩定的獲得合格沖裁件，通過分析端蓋的工藝性，確定合理的工藝方案；通過計算端蓋的相對直徑或者相對高度，判斷端蓋能否一次拉深成功，從而確定拉深工藝參數以及模具工作部分的幾何形狀與尺寸；根據計算結果選用標準表架。 關鍵詞：端蓋 應力狀態 工藝性 工藝方案 拉深次數 Gasket ramming craft and mold design Abstract：This mission is designed graduate washers parts mold design. Gaskets for flange cylinder-shaped pieces, is typical of drawing parts, Drawing its process of deformation of stress and deformation characteristics and without flange cylinder-shaped pieces are the same. But flange cylinder-shaped drawing, blank flange is not something all entered Die holes When drawing for diameter of the flange to flange diameter parts, drawing on the work to stop. Good technology and good process, with the least material, at least the processes and working hours. make simple structure Die Mold longevity, stability can be qualified blanking through analysis of the washers, determine reasonable process; By calculating the relative diameter washers or relative height, Can a judge washers Drawing successful, in order to determine drawing process parameters and die part of the geometric shape and size; According to the results table-selection criteria. Keywords : Washer Strain state Manufacturability Handicraft scheme Pull deep number of times